dimension witness line gap on drawings

I've been searching and have not found an answer so I'm creating a new post.

I'm working on a drawing in Creo  2.0.  I use Show Model Annotations to include a dimension which then appears on one side of the part with correct offset gaps between the witness lines and the part geometry.

Then I drag it to the other side to fit into the overall dimensioning plan better and the witness lines don't snap to offset properly to the new side.  They remain connected to the first side and I need to drag them individually.

Is there any way to change how this works?  If not, does anyone know if there is already a PI created to change this or if this will be fixed in 3.0?