I'm having a bit of a problem with a wire routing. When I create a new wire, I am unable to get the routing to process. I am unable to understand why this is, as the following conditions have been met:
1) network is continuous
2) spool is assigned
3) bend radius is adequate
4) the CSYS at both ends are undesignated. (designated on the fly)
5) "allow undesignated" is checked on both start and end locations
6) both CSYS are on the network path
The spool that is being used has been previously used to route hundreds of cables. To add to the frustration, I am unable to find any information regarding why this wire fails. No command feedback, no prompt info, nothing. The last bit of advice at the prompt, is to enter the ending point for the selected routing entry.
Obviously, a solution is great - but along with it, any tips or tricks for diagnosing routing failures would be more than appreciated.
Thank you in advance.