Show both dimenioan parameter & number at teh same time while modelling

So, I’d like to take more advantage of parametrics in Creo. When In used "that other program" I could set my dimensions to show the number, and the dimension label. It showed both. I could then make this dim=2/d34, and that dim =(d74+.25)/3, etc.. While I try this in Creo, I seem to have to constantly turn on & off the ‘switch symbol’ to get either a number or a parameter.. And I get the "Would you like to make this a relation" dialog each time. (Time consuming, but I don’t mind too much.) Can I have both the numer and the parameter shown at the same time?